User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
132
Configuring the GV-AS / GV-EV Controller on Internet
After acquiring a domain name from the DDNS Server, you need to configure the registered
domain name on the controller to access the controller by the domain name on Internet.
1. Open an Internet browser, and type the default IP address https://192.168.0.100
. The
login dialog box (Figure 7-2) appears.
2. In the User Name and Password fields, type default value admin and admin
respectively. Click OK. The Network Configuration page (Figure 7-10) appears.
3. Click Enable, and select Send to DDNS.
4. Type Host Name, User Name and Password that are registered on the DDNS Server. If
you select GeoVision DDNS, the system will automatically bring up the Host Name.
Figure 7-10
5. Click Submit. When the setting is complete, the Status field will indicate: Register
Success. Then GV-AS / GV-EV Controller can be accessed with the domain name.