User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
The Web Interface
139
8
8.2 Advanced Settings
To configure the Advanced Setting on the Web interface, set the Web Setting switch on the
GV-AS / GV-EV Controller to ON. See the Web Setting Switch section of each controller
chapter.
Under Advanced Settings, you can configure door/Wiegand settings, turn on Alarms, set the
device time and edit the input/output functions.
Changes in some of the Advanced Settings pages will affect the options available on other
pages. Below is a diagram drawing the relationships between each Advanced Settings page.
The Relationship Diagram between each Advanced Setting Page
Affects
Affects
Figure 8-6
Note:
1. For GV-AS1010 and GV-AS1110, a Card Configuration page and a Card Information
page are available.
2. For GV-AS1010, a Function Key Configuration page is available.