User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
142
[ID]
Enter the ID number for the controller. This ID is used by GV-ASManager to differentiate
among multiple units of controller. ID number can only be between 1 and 1000.
[Door/Gate #] [Elevator]
Select the function type and authentication mode for the use of the Doors/Gates. For GV-
EV48, select an authentication mode to apply to all floors of the elevator.
Function: Select the function for the reader connected to the Door/Gate.
Door Control: The reader is installed in a general door for access control.
Parking Control: The reader is installed in a parking place for access control.
Elevator Control: The reader is installed in an elevator for access control.
Authentication Mode: Select the authentication mode for the Doors/Gates or Elevator.
Local Unlock Mode: Remains open. The held-open state cannot be cleared
through GV-ASManager.
Local Lock Mode: Remains locked. The locked state cannot be cleared through
GV-ASManager.
Fixed Card Mode: Grants access after the card is presented or the passcode is
entered, and ignores the authentication schedule of GV-ASManager.
Fixed Card + PIN Mode: Grants access after the user presents the card and enters
the card’s PIN code, and ignores the authentication schedule of GV-ASManager.
Fixed Card/Common mode: Grants access after the user presents the card or
enters the door’s password, and ignores the authentication schedule of GV-
ASManager.
Authentication Schedule Mode: Follows the authentication schedule set on GV-
ASManager.
Local Lock Down: Locks down the door. This mode overrides the Authentication
Schedule and the door can only be opened by presenting the assigned access card.
This function is only available in GV-AS1010 / 1110.