User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
156
Gate # Fire Sensor
Tamper Zone
Exit Button
Car Detection
See the “Door #” Input Type above.
For example, when the Car Detection sensor
detects any car driving by, a “Park Entry” or
“Park Exit” type of event occurs and the
parking gate will respond the event
accordingly.
Relay # Fire Sensor
Tamper Zone
See the “Door #” Input Type above.
For example, the Tamper Zone sensor is
installed on GV-AS Controller. So whenever
there is any attempt to open the GV-AS
Controller’s cabinet, the “Tamper” type of
event occurs and the event may trigger the
“Tamper” alarm.
Note: For alarm outputs, the corresponding alarms must be enabled (YES) in the
Parameter Configuration page (Figure 8-9). If alarms are set to be disabled (NO), then
the alarm function here will not work when triggered.