User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
The Web Interface
163
8
8.2.9 Function Key Configuration
In the left menu, click Function Key Configuration to define the function keys on GV-
AS1010.
Figure 8-24
Set the function keys to be the start or end of Work Time, Away, Overtime or Break Time.
When employees present their access card to GV-AS1010, they can press the function keys
to indicate the card swipe as the start or end of Work Time, Away, Overtime or Break Time.
If you select Authenticate, the door or elevator call button will be unlock when the user
present the access card after pressing a function key.
The attendance record can be looked up in GV-TAWeb. Refer to Chapter 11 GV-TAWeb for
Workforce Schedule and Payroll in GV-ASManager User’s Manual for details.
Note: The Function Key Configuration page is only available for GV-AS1010.