User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
166
[Read Mode] Select Read UID or Read GID to set the connected GV-R1352 / RK1352 /
DFR1352 (Rev. B) to read UID (unique identifier) or GID (GeoVision ID) on the card / key
fob. If you select Read GID, make sure there are two numbers on your GV-AS ID Cards /
Key Fobs as shown below. If there is only one number on your GV-AS ID Cards / Key Fobs,
GID is not supported and you must select Unique Identification (UID).
Figure 8-26
[GeoFinger Server IP Address] To allow GV-ASManager to receive data from the GV-
GF1921 / 1922 defined on this page during remote fingerprint enrollment, type the IP
address and port of the GV-ASManager’s GeoFinger Server. You can also complete this
step on the Web interface of each GV-GF1921 / 1922 individually as shown below.
Figure 8-27
Note: GID is only supported by GV-R1352 / RK1352 / DFR1352 (Rev. B) with firmware
V1.2 or later.