User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
Optional Devices
171
9
9.1.4 Installation
This section describes how to connect other devices to GV-ASBox.
9.1.4.A Connecting GV-AS100 / 110 / 120
The table and figure below show the pin assignments of related connectors on GV-ASBox
for connection to GV-AS100, GV-AS110 and GV-AS120.
GND
12V
A+
A-
B+
B-
GV-AS100/110/120
GV-Readers
RS-485_A TERM
RS-485_B TERM
Figure 9-2
Pin Function Pin Function Pin Function
12V
12V Power Supply to
GV-AS100/110/120
A+
GV-AS100/110/120
Connection
B+
GV-Readers
Connection
GND
GND for Power Supply to
GV-AS100/110/120
A-
GV-AS100/110/120
Connection
B-
GV-Readers
Connection
Note:
1. By default, RS-485_A Term and RS-485_B Term are set to OFF.
2. When the distance between the GV-ASBox and the GV-AS100 / 110 / 120 is over a long
distance, RS-485_A Term must be switched to ON. When the distance between the
GV-ASBox and the GV-Readers is over a long distance, RS-485_B Term must be
switched to ON.