User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
178
9.1.4.G Other Settings
The figure below shows the location of the Web Setting Switch, Reset Button and Default
Button.
Default
Reset EN
Figure 9-8
9.1.4.G.a Web Setting Switch
When the Web Setting switch is set to ON, you can modify Advanced Settings of GV-
AS100, GV-AS110 and GV-AS120 through the Web interface. When the switch is set to
OFF, Advanced Settings are not accessible. For details on Advanced Settings, see 9.3.2
Advanced Settings.
9.1.4.G.b Resetting the GV-ASBox
To reset GV-ASBox, press the Reset EN button on GV-ASBox for 3 seconds.
9.1.4.G.c Restoring Factory Defaults
To restore factory default values, press the Default button on GV-ASBox for 3 seconds. After
this it may take up to 3 minutes to restore GV-ASBox to default values.