User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
Optional Devices
183
9
9.2.4.B Connecting GV-Readers and GV-GF Fingerprint Readers
You can connect up to 2 units of GV-Readers and GV-GF Fingerprint Readers to GV-
ASNet. Multiple GV-Readers and GV-GF Fingerprint Readers can be connected with a
single RS-485 cable to the RS485 B+ and B- on GV-ASNet. You will need to connect the
GV-Readers or GV-GF Fingerprint Readers to external power supply.
The figure and table shows the pin assignments for related connectors.
Figure 9-11
Pin Function Pin Function
RS485B+
GV-Reader / GV-GF
Fingerprint Readers
Connection
RS485B-
GV-Reader / GV-GF
Fingerprint Readers
Connection
To define each GV-Reader and GV-GF Fingerprint Reader, you need to use the GV-AS100 /
110 / 120 Web interface. See 9.3.2.G Extended Reader.