User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
192
9.3.2.B Parameter Setting
In the left menu, click Parameter Setting. This AS100/AS110/AS120 Configuration page
appears. The contents of Parameter Setting change based on your settings for Door/Gate A
and Door/Gate B in the Function Setting page (Figure 9-15).
Figure 9-16
Note: The Door B settings and Input Name settings are only available when connecting
through GV-ASBox.
IMPORTANT: Once connecting to GV-AS100 / 110 / 120, GV-ASManager will load its
parameters to the GV-AS Controller. That means some of the Parameter Settings you have
configured here may be rewritten by GV-ASManager later.