User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
196
9.3.2.C Status Monitor
In the left menu, click Status Monitor to see the status of each input, output and alarm
Figure 9-20
Control Mode will change depending on the chosen Door/Gate’s Authentication Mode in
the Function Setting page (Figure 9-15). The listed number of outputs will change
depending on the chosen Output Type in the In/Out Function page (Figure 9-23).
= Indicates the current input/output device is triggered.
= Indicates the current input/output source is not triggered.
= Indicates the current event is triggered.
= Indicates the current light is on.
= Indicates the current light is off.
Note: The Status Monitor page is only available when connecting through a GV-ASBox.
Note: Outputs must be turned on in the In/Out Function page to be monitored here.