User Manual

Optional Devices
201
9
• When Elevator Control is selected in the Function Setting page (Figure 9-15), these
Input Type and Input Function become available:
Input Type Input Function Description
Normal Input Enable Latch
Disable Latch
See the same Input Type above.
Relay A or B Fire Zone
Tamper Zone
See the “Door A or Door B” Input Type above.
For example, the Tamper Zone sensor is
installed on GV-ASBox. So whenever there is
any attempt to open the Box, the “Tamper” event
occurs and it may trigger the “Tamper” alarm.
[Output Function]
Here you can define each output device that is connected to GV-ASBox, such as locking
devices, various alarms or Exit Button. Only Output 5 to Output 8 can be connected to
Lights.
Select from the drop-down list to configure Output Type (No. 1, Figure 9-25). Depending on
the chosen Output Type, either Output Function (No. 2, Figure 9-25) or Output
Conditions (No. 3, Figure 9-25) will become available.
Figure 9-25
Note: For alarm outputs, the corresponding alarms must be enabled (YES) in the
Parameter Setting page (Figure 9-16). If alarms are set to be disabled (NO), the alarm
function here will not work when triggered.
1
1
2
3
Output Function
Output Conditions
Output Type