User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
206
9.3.2.G Extended Reader
In the left menu, click Extend Reader. This Extend Reader Configuration page appears.
Figure 9-28
Define the readers connected to GV-AS100 / 110 / 120, and then use the Function drop-
down list to select which door that the GV-Reader/GV-GF Fingerprint Reader is installed.
[GV-Reader Function]
• GV-RK1352 / R1352 / DFR1352: Select the checkbox and type the Serial Number of
the reader. Note that the ID number located next to the serial number field need to match
the reader’s ID number defined through the GV-RK1352 Config AP.
• GV-Reader 1251 / Reader 1352 V2: Select the checkbox and leave the serial number
field blank. Note that the ID number located next to the serial number field need to match
the reader’s ID number defined by the dip switches on the reader.
• GV-CR420: Type the Barcode of GV-CR420. Select the checkbox only if the GV-CR420
is connected to the controller through RS-485 connection. For network connection, do
not select the checkbox. Note that only GV-CR420 V1.0 is compatible with GV-AS100 /
110 / 120 and you must also enable network connection to the controller on the Web
interface of the GV-CR420.