User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
8
1.2.1 Connecting Card Readers
1.2.1.A Wiegand Readers (GV-AS100 Only)
GV-AS100 provides one Wiegand input for connection of the Wiegand reader ranging from
26 to 64 bits. Through the GV-AS100 keypad, you can set the Wiegand reader as the entry
or exit reader. To define the reader, see the AS100 Function option in 1.3.5 Setting
Parameters.
Note: Wiegand connection is not supported for GV-AS1010.
The table below shows the pin assignments of the Wiegand input on GV-AS100. Please
consult the documentation of your Wiegand reader for wiring.
Pin Function
7 Wiegand Data 0
8 Wiegand Data 1
9 12V Power Supply
10 GND