User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
14
1.2.4 Connecting the PC
Connecting GV-AS110 / 1110 to a computer allows you to access its Web interface and
connect it to GV-ASManager if the computer is installed with GV-ASManager. GV-
ASManager software can monitor the access information and alarm messages from GV-
AS100 / 1010. The communication link between the computer and GV-AS100 / 1010 is as
below.
GV-AS100: RS-485 connection or network connection
• RS-485 connection: a RS-485 to RS-232 converter is required
• Network connection: an optional GV-ASBox or GV-ASNet is required
GV-AS1010: Network connection
IMPORTANT: To enable connection to PC on GV-AS100, Switch 1 must be turned on. See
1.2.4.C Switches.