User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
18
1.2.6 Fitting the Battery
GV-AS100 / 1010 includes a battery, providing power to GV-AS100 / 1010 settings and real-
time clock circuitry. When the power in the battery becomes low, the message “Low Battery”
will appear on GV-AS100 / 1010 LCD. In this case, replace the battery. All settings on GV-
AS100 / 1010 will disappear about 10 hours after the battery stops working, and GV-AS100 /
1010 will be restored to default settings.
GV-AS100 GV-AS1010
Figure 1-14
Note:
1. Make sure the plastic insulation film under the battery is removed.
2. It is recommended to replace the battery annually. GV-AS100 uses a 3V lithium
battery that can be purchased on your own. For GV-AS1010, contact your sales
representative to acquire replacement batteries designated for GV-AS1010.