User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
GV-AS100 / 1010 Controller
21
1
The table below shows the codes to start various programming and display system
information.
Code Function
＊227 (＊CAR) Accesses the Card Manager function.
＊276 (＊ARM) Accesses Security Mode.
＊347 (＊DIS) Displays system information.
＊738 (＊SET) Accesses parameter settings.
＊737 (＊RES) Restores GV-AS100 / 1010 to factory defaults.
＊837 (＊TES) Tests numeral keys to see if they can be displayed properly.
Before programming GV-AS100 / 1010, you also need to know the following keys.
Key Function
＊ Used to cancel the selection, or go back to the previous page.
# Used to save the data that was modified or programmed in the
system and quit.
0 Used to go to the next page.