User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
GV-AS100 / 1010 Controller
27
1
1.3.5 Setting Parameters
You can define the parameters of some features on GV-AS100 / 1010.
IMPORTANT: Once connecting to GV-AS100 / 1010, GV-ASManager will load its
parameters to GV-AS100 / 1010. That means some of the parameters you set up here may
be overwritten by GV-ASManager later.
1. Press the code ＊738 (＊SET).
2. Present the Master Card and enter its PIN code. The LCD displays Set Local Time.
3. Press 0 to change the options. Press # to select the option for further programming.
Option Function
Set Local Time Sets the time, time zone and enables daylight saving.
Set AS100 / 1010 ID
Sets the ID of GV-A100 / 1010 from 1 to 255.
Set AS1010 IP Sets the IP of GV-AS1010. (GV-AS1010 only)
Set Auth. Mode Sets an authentication mode for the door/gate.
Auth. Schedule: Follows the authentication schedule set on
GV-ASManager.
Fixed Card Mode: Grants access after the card is presented.
Ignores the authentication schedule of GV-ASManager.
Fixed Card + PIN: Grants access after the user presents the
card and then enters the card’s PIN code. Ignores the
authentication schedule of GV-ASManager.
Fixed Card/Common: Grants access after the user presents
the card or enters the door’s password. Enter the door’s
password after the LCD displays Common Password.Ignores
the authentication schedule of GV-ASManager.
Local Unlock Mode: Remains open. The held-open state
cannot be cleared through GV-ASManager.
Local Lock Mode: Remains locked. The locked state cannot
be cleared through GV-ASManager.