User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
GV-AS100 / 1010 Controller
31
1
1.4 Web-Based Configurations
GV-AS100
Through GV-ASBox or GV-ASNet, GV-AS100 can communicate with GV-ASManager over
the network. Using GV-ASBox or GV-ASNet, you can also access the Web interface of GV-
AS100.
Refer to Chapter 9 Optional Devices to see how to connect a GV-ASBox or GV-ASNet and
how to access the Web interface of GV-AS100.
GV-AS1010
GV-AS1010 can communicate with GV-ASManager over the network. The network interface
also allows you to access the Web interface of GV-AS1010.
Refer to Chapter 7 Installing on a Network for detailed instructions on setting a fixed or
dynamic IP address to access GV-AS1010.
Refer to Chapter 8 The Web Interface for details on the setup pages of the Web interface.
Through the Web interface, you can configure general settings, input/output devices,
associated doors/gates and connected readers.