User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
GV-AS110 / 1110 Controller
35
2
2.1 Introduction
GV-AS110 / 1110 is a single door controller with a built-in reader. You can connect one
more card reader to GV-AS110 and up to two more card readers to GV-AS1110 for entry
and exit applications. GV-AS110 comes with built-in RS-485 and Wiegand interface, while
GV-AS1110 comes with TCP/IP network port.
GV-AS110 / 1110 has the capability to store up to one thousand cards under standalone
mode and up to 40,000 cards when connected to GV-ASManager. Programming of GV-
AS110 / 1110 can be done either on the keypad or from the software GV-ASManager.
An economic solution for access control, GV-AS110 / 1110 is suitable for controlling doors,
parking gates and access to elevator call buttons.
Figure 2-1