User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
48
2.3 Programming Mode
After powering on GV-AS110 / 1110, you must create two cards first, an Enroll Card and a
Delete Card. The Enroll Card is used for adding new cards and the Delete Card is used for
deleting cards. Either card will allow you to program the various configurations on GV-AS110
/ 1110.
Note: Cards complying with ISO 14443A standard for smart card technology can be
formatted as an Enroll Card or Delete Card.
To create the Enroll Card and the Delete Card:
1. Power on the unit. The LED flashes blue.
2. Present a card to be the Enroll Card.
3. Present a card to be the Delete Card.
After 1 to 2 minutes, the LED should be a constant blue light to indicate READY.
2.3.1 Adding and Deleting Cards
Using the two cards, you can add new cards to GV-AS110 / 1110 and delete existing cards
on GV-AS110 / 1110.
Note:
1. GV-ASManager cannot manage the cards enrolled on GV-AS110 / 1110, since the card
data will not be transmitted to GV-ASManager.
2. The cards added through GV-ASManager cannot be deleted on GV-AS110 / 1110.