User Manual
Table Of Contents
- Welcome
- Important Notes for Maintaining Power Supply
- Elevator Control
- Optional Devices
- Installation Considerations
- Firmware and Software Compatibility
- Definition
- 1. GV-AS100 / 1010 Controller
- 1.1 Introduction
- 1.2 Installation
- 1.3 Programming Mode
- 1.4 Web-Based Configurations
- 1.5 GV-AS100 / 1010 Specifications
- 2. GV-AS110 / 1110 Controller
- 3. GV-AS120 Controller
- 4. GV-AS210 / 2110 / 2120 Controller
- 5. GV-AS410 / 4110 / 810 / 8110 Controller
- 6. GV-EV48 Controller
- 7. Installing on a Network
- 8. The Web Interface
- 9. Optional Devices
- 9.1 Optional GV-ASBox
- 9.1.1 Main Features
- 9.1.2 Packing List
- 9.1.3 GV-ASBox Board Layout
- 9.1.4 Installation
- 9.1.5 GV-ASBox Specifications
- 9.2 Optional GV-ASNet
- 9.3 Web Interface through Optional Devices
- 9.1 Optional GV-ASBox
- 10. Troubleshooting
- Appendix
70
3.3.1.A Adding a Card
Up to 1,000 cards can be enrolled on GV-AS120 directly without needing additional software.
When working with GV-ASManager software, GV-AS120 can support up to 40,000 cards.
1. Present the Enroll Card.
2. Present the card you want to add to the GV-AS120.
3. The GV-AS120 will produce a long beep if the card has been added successfully and
three short beeps if the adding procedure has failed.
The default password will be 1234 and the card will automatically be set to a Normal Card.
You can change the password and set the card to different card types such as Patrol Card
or Two-person A/B Card using GV-ASManager. Refer to the Adding Cards section in GV-
ASManager User’s Manual for more details.
Note: GV-AS120 does not support cards set up as Security Cards.
3.3.1.B Deleting a Card
1. Present the Delete Card.
2. Present the card you want to delete.
3. The GV-AS120 will produce a long beep if the card has been deleted successfully and
three short beeps if the deleting procedure has failed.