User Manual
Table Of Contents
- Naming Definition
- Options
- Note for Connecting to GV-System / GV-VMS
- Note for Installing Camera Outdoor
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 Accessing the Camera
- 3.1 Accessing Your Surveillance Images
- 3.2 The Live View Window
- 3.3 The Control Panel of the Live View Window
- 3.4 Snapshot of a Live Video
- 3.5 Video Recording
- 3.6 Picture-in-Picture and Picture-and-Picture View
- 3.7 Alarm Notification
- 3.8 Video and Audio Configuration
- 3.9 Remote Configuration
- 3.10 Camera Name Display
- 3.11 Image Enhancement
- 3.12 I/O Control
- 3.13 Visual Automation
- Chapter 4 Administrator Mode
- Chapter 5 Advanced Applications
- Chapter 6 DVR Configurations
- Chapter 7 CMS Configurations
- Chapter 8 Smart Device Connection
- Chapter 9 GV-ASManager Connection
- Specifications
- Appendix
118
[Host Settings] Enter a descriptive name for the camera.
[Auto Reboot Setup] Select Enable to activate automatic reboot and specify the time for
reboot in the sub fields below.
Day Interval: Type the day interval between the reboots.
Reboot Time: Use the drop-down list to specify the time for automatic reboot.
[Firmware Update] This field displays the firmware version of the camera.
[System Settings] Click a Load Default button to restore the factory default settings with the
network settings restored or not restored.
Note: After applying the default function, the default network connection will be DHCP or
fixed IP (192.168.0.10) if the router does not support DHCP. Re-configure your network
settings if necessary.
[Internal Temperature] This field displays the current chipset temperature inside the camera.
[Fan Status] This field shows whether the fan of the camera is enabled or not. Note this
function is only supported by GV-LPC1200 / GV-LPR1200.
[Reboot] Click the Reboot button to reset the software configuration of the camera.