User Manual
Table Of Contents
- Naming Definition
- Options
- Note for Connecting to GV-System / GV-VMS
- Note for Installing Camera Outdoor
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 Accessing the Camera
- 3.1 Accessing Your Surveillance Images
- 3.2 The Live View Window
- 3.3 The Control Panel of the Live View Window
- 3.4 Snapshot of a Live Video
- 3.5 Video Recording
- 3.6 Picture-in-Picture and Picture-and-Picture View
- 3.7 Alarm Notification
- 3.8 Video and Audio Configuration
- 3.9 Remote Configuration
- 3.10 Camera Name Display
- 3.11 Image Enhancement
- 3.12 I/O Control
- 3.13 Visual Automation
- Chapter 4 Administrator Mode
- Chapter 5 Advanced Applications
- Chapter 6 DVR Configurations
- Chapter 7 CMS Configurations
- Chapter 8 Smart Device Connection
- Chapter 9 GV-ASManager Connection
- Specifications
- Appendix
Administrator Mode
75
4
4.2 I/O Control
Note this function is only supported by cameras with I/O function. You can connect your
camera to other I/O devices with the I/O wires for extensible connection. Strip the desired
wires first, and connect the auxiliary devices with the right wires according to the assignments
to the wires in 1.3.5.3 Wire Definition.
4.2.1 Input Settings
To activate the sensor input, select Enable.
Figure 4-12
Normal State: You can set the input state to trigger actions by selecting Open Circuit
(N/O) or Grounded Circuit (N/C).
Latch Mode: Enable this option to have a momentary output alarm.
Trigger digital output relay: When this option is enabled, the output will be triggered
once the input is activated.
Send Video to Center V2: Enable this option to send the images to Center V2 when the
input is triggered.