Quick Start Guide
Table Of Contents
- Contents
- Introduction
- Options
- Note for Connecting to GV-System / GV-VMS
- Note for Recording
- Note for Adjusting Focus and Zoom
- Note for Installing Camera Outdoor
- Note for Closing the Bullet Camera Cover
- Note for Bullet Waterproof Failures
- Note for USB Storage and WiFi Adapter
- Note for Silica Gel Bags
- 1. Box Camera
- 2. Ultra Box Camera
- 3. Target Box Camera
- 4. IR Arctic Box Camera
- 5. Mini Fixed Dome & Mini Fixed Rugged Dome
- 6. Target Mini Fixed Dome
- 7. Target Mini Fixed Rugged Dome
- 8. Bullet Camera (Part I)
- 9. Bullet Camera (Part II)
- 10. Bullet Camera (Part III)
- 11. Ultra Bullet Camera
- 12. Target Bullet Camera (Part I)
- 13. Target Bullet Camera (Part II)
- 14. Vandal Proof IP Dome (Part I)
- 15. Vandal Proof IP Dome (Part II)
- 16. Vandal Proof IP Dome (Part III)
- 17. Target Vandal Proof IP Dome
- 18. Fixed IP Dome
- 19. Target Fixed IP Dome
- 20. Cube Camera
- 21. Advanced Cube Camera
- 22. PT Camera
- 23. Pinhole Camera
- 24. Accessing the Camera
- 25. The Web Interface
- 26. Upgrading System Firmware
- 27. Restoring to Default Settings
- 27.1 Using the Web Interface
- 27.2 Directly on the Camera
- Box Camera
- Ultra Box Camera and Target Box Camera
- Mini Fixed Dome
- Mini Fixed Rugged Dome
- IR Arctic Box Camera
- Target Mini Fixed Target Mini Fixed Rugged Dome
- Bullet Camera
- Ultra Bullet Camera
- Target Bullet Camera
- Vandal Proof IP Dome
- Fixed IP Dome
- Target Fixed IP Dome
- Cube Camera
- Advanced Cube Camera
- PT Camera
- Pinhole Camera
IMPORTANT:
1. Use the supplied ruler and leave about 10 cm of audio, power,
and I/O wires between their connectors and the cable seal.
2. The plugs are used to prevent water from entering the camera
housing. Keep the unused holes plugged and save the
removed plugs for future use.
3. Only thread the wires through their designated holes on the
conduit connector to make sure the wires are properly sealed.
9. Install the base to the back plate on the wall.
10. Connect the wires to the camera.
A. Install the terminal blocks to the power adapter and I/O devices.
See Power Connection and I/O Device Connections in 9.5
Connecting the Camera.
B. Install the supplied RJ-45 connector to the Ethernet cable.
C. Plug all the connectors to the camera panel.
11. Tie the wires with the supplied cable tie and re-install the base to the
camera. You may need to rotate the base for the wires to fit.
84