Quick Start Guide
Table Of Contents
- Contents
- Introduction
- Options
- Note for Connecting to GV-System / GV-VMS
- Note for Recording
- Note for Adjusting Focus and Zoom
- Note for Installing Camera Outdoor
- Note for Closing the Bullet Camera Cover
- Note for Bullet Waterproof Failures
- Note for USB Storage and WiFi Adapter
- Note for Silica Gel Bags
- 1. Box Camera
- 2. Ultra Box Camera
- 3. Target Box Camera
- 4. IR Arctic Box Camera
- 5. Mini Fixed Dome & Mini Fixed Rugged Dome
- 6. Target Mini Fixed Dome
- 7. Target Mini Fixed Rugged Dome
- 8. Bullet Camera (Part I)
- 9. Bullet Camera (Part II)
- 10. Bullet Camera (Part III)
- 11. Ultra Bullet Camera
- 12. Target Bullet Camera (Part I)
- 13. Target Bullet Camera (Part II)
- 14. Vandal Proof IP Dome (Part I)
- 15. Vandal Proof IP Dome (Part II)
- 16. Vandal Proof IP Dome (Part III)
- 17. Target Vandal Proof IP Dome
- 18. Fixed IP Dome
- 19. Target Fixed IP Dome
- 20. Cube Camera
- 21. Advanced Cube Camera
- 22. PT Camera
- 23. Pinhole Camera
- 24. Accessing the Camera
- 25. The Web Interface
- 26. Upgrading System Firmware
- 27. Restoring to Default Settings
- 27.1 Using the Web Interface
- 27.2 Directly on the Camera
- Box Camera
- Ultra Box Camera and Target Box Camera
- Mini Fixed Dome
- Mini Fixed Rugged Dome
- IR Arctic Box Camera
- Target Mini Fixed Target Mini Fixed Rugged Dome
- Bullet Camera
- Ultra Bullet Camera
- Target Bullet Camera
- Vandal Proof IP Dome
- Fixed IP Dome
- Target Fixed IP Dome
- Cube Camera
- Advanced Cube Camera
- PT Camera
- Pinhole Camera
3. Install the Ethernet cable.
A. Rotate to remove the indicated cap and the plug inside.
B. Thread an Ethernet cable (the end with no RJ-45 connector) from
the back panel through the cable seal.
IMPORTANT: Use the supplied ruler and leave about 11 cm of the
Ethernet cable between the connector and the cable seal.
C. Re-install the cap. Make sure the cap is installed tightly to
waterproof the camera.
152