Quick Start Guide
Table Of Contents
- Contents
- Introduction
- Options
- Note for Connecting to GV-System / GV-VMS
- Note for Recording
- Note for Adjusting Focus and Zoom
- Note for Installing Camera Outdoor
- Note for Closing the Bullet Camera Cover
- Note for Bullet Waterproof Failures
- Note for USB Storage and WiFi Adapter
- Note for Silica Gel Bags
- 1. Box Camera
- 2. Ultra Box Camera
- 3. Target Box Camera
- 4. IR Arctic Box Camera
- 5. Mini Fixed Dome & Mini Fixed Rugged Dome
- 6. Target Mini Fixed Dome
- 7. Target Mini Fixed Rugged Dome
- 8. Bullet Camera (Part I)
- 9. Bullet Camera (Part II)
- 10. Bullet Camera (Part III)
- 11. Ultra Bullet Camera
- 12. Target Bullet Camera (Part I)
- 13. Target Bullet Camera (Part II)
- 14. Vandal Proof IP Dome (Part I)
- 15. Vandal Proof IP Dome (Part II)
- 16. Vandal Proof IP Dome (Part III)
- 17. Target Vandal Proof IP Dome
- 18. Fixed IP Dome
- 19. Target Fixed IP Dome
- 20. Cube Camera
- 21. Advanced Cube Camera
- 22. PT Camera
- 23. Pinhole Camera
- 24. Accessing the Camera
- 25. The Web Interface
- 26. Upgrading System Firmware
- 27. Restoring to Default Settings
- 27.1 Using the Web Interface
- 27.2 Directly on the Camera
- Box Camera
- Ultra Box Camera and Target Box Camera
- Mini Fixed Dome
- Mini Fixed Rugged Dome
- IR Arctic Box Camera
- Target Mini Fixed Target Mini Fixed Rugged Dome
- Bullet Camera
- Ultra Bullet Camera
- Target Bullet Camera
- Vandal Proof IP Dome
- Fixed IP Dome
- Target Fixed IP Dome
- Cube Camera
- Advanced Cube Camera
- PT Camera
- Pinhole Camera
Pan Adjustment
IMPORTANT:
1. Loosen the Base Screw (No. 3, 16.2 Overview) before adjusting the
camera pan angle.
2. The front of the camera is marked with a white line in front of the
memory card slot. When adjusting the camera pan angle, avoid
turning the camera for more than 180 degrees in either direction.
Continuous rotation greater than 180 degrees could pull off the
internal cable and cause the camera to malfunction.
Rotational Adjustment
Tilt Adjustment
168