Quick Start Guide
Table Of Contents
- Contents
- Introduction
- Options
- Note for Connecting to GV-System / GV-VMS
- Note for Recording
- Note for Adjusting Focus and Zoom
- Note for Installing Camera Outdoor
- Note for Closing the Bullet Camera Cover
- Note for Bullet Waterproof Failures
- Note for USB Storage and WiFi Adapter
- Note for Silica Gel Bags
- 1. Box Camera
- 2. Ultra Box Camera
- 3. Target Box Camera
- 4. IR Arctic Box Camera
- 5. Mini Fixed Dome & Mini Fixed Rugged Dome
- 6. Target Mini Fixed Dome
- 7. Target Mini Fixed Rugged Dome
- 8. Bullet Camera (Part I)
- 9. Bullet Camera (Part II)
- 10. Bullet Camera (Part III)
- 11. Ultra Bullet Camera
- 12. Target Bullet Camera (Part I)
- 13. Target Bullet Camera (Part II)
- 14. Vandal Proof IP Dome (Part I)
- 15. Vandal Proof IP Dome (Part II)
- 16. Vandal Proof IP Dome (Part III)
- 17. Target Vandal Proof IP Dome
- 18. Fixed IP Dome
- 19. Target Fixed IP Dome
- 20. Cube Camera
- 21. Advanced Cube Camera
- 22. PT Camera
- 23. Pinhole Camera
- 24. Accessing the Camera
- 25. The Web Interface
- 26. Upgrading System Firmware
- 27. Restoring to Default Settings
- 27.1 Using the Web Interface
- 27.2 Directly on the Camera
- Box Camera
- Ultra Box Camera and Target Box Camera
- Mini Fixed Dome
- Mini Fixed Rugged Dome
- IR Arctic Box Camera
- Target Mini Fixed Target Mini Fixed Rugged Dome
- Bullet Camera
- Ultra Bullet Camera
- Target Bullet Camera
- Vandal Proof IP Dome
- Fixed IP Dome
- Target Fixed IP Dome
- Cube Camera
- Advanced Cube Camera
- PT Camera
- Pinhole Camera
228
22.4 Connecting the Camera
13 4 2
2
1. Use a standard network cable to connect the camera to your network.
2. Optionally connect a speaker and an external microphone.
3. Connect power using one of the following methods:
• plugging the power adapter to the power port.
• using the Power over Ethernet (PoE) function to provide power
over the network cable.
4. Optionally connect to an input / output device. For details, see I/O
Terminal Block, PTZ Camera Chapter, GV-IPCAM Firmware Manual
on the Software DVD.
5. The status LED of the camera will be on.
6. Access the camera See 24. Accessing the Camera in the Quick Start
Guide.
7. Adjust for image clarity using GV-IP Device Utility. For details, see
24.3 Adjusting Image Clarity in the Quick Start Guide.