Quick Start Guide

備註：
1. 讀卡機與控制器之間請使用22AWG以上的雙隔離網鋁箔麥拉對絞傳輸線。
2. 為了減低遠距離雜訊，傳輸線的隔離網地應接兩端裝置的地。
3. 建議兩個讀卡機之間的距離最少30公分以上。
4. 避免安裝在金屬物週邊，以免影響感應距離。
5. 讀卡機與控制器的距離建議不要超過30米。
6. 供應讀卡機之電源,建議使用非交換式的線性直流電源,以確保得到最佳的感應距離。
7. 為確保讀卡機的正常運作,輸入電源請確保在12V±10%之間。
8. 如安裝在露天或高濕度易滲水的環境,建議另行加裝防水罩。
9. RS-485 通訊Baud rate 為9600。
備註：
1. 讀卡機與控制器之間請使用22AWG以上的雙隔離網鋁箔麥拉對絞傳輸線。
2. 為了減低遠距離雜訊，傳輸線的隔離網地應接兩端裝置的地。
3. 建議兩個讀卡機之間的距離最少30公分以上。
4. 避免安裝在金屬物週邊，以免影響感應距離。
5. 讀卡機與控制器的距離建議不要超過30米。
6. 供應讀卡機之電源,建議使用非交換式的線性直流電源,以確保得到最佳的感應距離。
7. 為確保讀卡機的正常運作,輸入電源請確保在12V±10%之間。
8. 如安裝在露天或高濕度易滲水的環境,建議另行加裝防水罩。
9. RS-485 通訊Baud rate 為9600。
將卡片靠近讀卡機,同時聽到“嗶”聲提示.
將卡片靠近讀卡機,同時聽到“嗶”聲提示.
Place the card provided near the reader.
The reader will beep concurrently.
打開電源亮
紅色燈 ,同時聽到“嗶”聲提示.
打開電源亮
紅色燈 ,同時聽到“嗶”聲提示.
When the power is on, the reader's red LED
and the reader will beep concurrently.
Testing
/測試/
測試
Card
5
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one of the
following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, any changes or
modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
(Example - use only shielded interface cables when connecting to
computer or peripheral devices)
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may
cause undesired operation.