User`s manual
Table Of Contents
- Copyright
- Contents
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 System Configuration
- Chapter 4 Video Playback
- Chapter 5 Remote Access to the GV-SNVR
- Chapter 6 Advanced Applications
- Specifications
- Appendix
12
3. Place the hard drive in the drive drawer as below by aligning the three holes.
Figure 2-3
4. Secure the hard drive with the drive drawer using the supplied 6 screws (3 screws on
each side).
Figure 2-4
5. Connect the SATA Power Cable and Data Cable to the hard drive.
Figure 2-5
6. Put the drive drawer back in the device and secure the two screws on the drive drawer
(Figure 2-2).
7. Assemble the cover with the device by tightening the screws on rear panel (Figure 2-2).
The hard drive is now ready to use.