TABLE OF CONTENTS PG English section 1 Spanish session co 13 Before Your Installation Check to nuke sure you have the following parts indicated below. ante © 2008 Dane, inc. All rights reserved.
Tools Required Adjustable wrench Groove joint pliers Phillips screwdriver Operation Manual DAZE ALWAYS RECOMMENDS THAT PLUMBING PRODUCTS BE INSTALLED BY A CENSUSED PROFESSIONAL 1. BEFORE YOU BEGIN IMPORTANT INSTRUCTIONS READ AND SAVE FOR THE CONSUMER | WARNING : Risk of scalding or other severe injury. Before completing installation, the installer must set the maximum wets temperature setting of this valve to minimize the risks associated with scolding hoards.
if another range of temperatures is desired or the usual water supply conditions differ significantly, you will need fo re calibrate the valve settings according to our rim installation procedure. If a medium Ba water temperature is required, you also may dean to re calibrate the valve. Again, please see our rim installation procedures for re calibration procedures. CAUTION : RISK OF SCALDING HAZARD The valve has been calibrated af the factory to deliver weer of approximately 100° F {38° CJ.
The shower system shown below ls just one of many ways to configure a Bone 3/4° Thermostatic shower system, Please consult with your plumbing professional for additional options. 19-120 2008 Dane, Inc. All rights reserved.
» Dane Thermostatic mixing valve includes integral mounting bots to facilitate installation. You moy mount the valve directly onto the wall framing if you chooses. Connect the hot water supply to inst marked “H”, and the cold water supply to the inst marked “C”. Do net solder ths connections between ths pipes and valve body. Tha inlet and outlet ports are threaded fo accept a 3/47 NPT filing. Sweat the pips to the appropriators fighting adapter. Seal the unused culls with a screw plug [supplied].
% For shower applications, Dane doss not recommend plumbing outlet pipes to Beth the upper and lower outlets on the 3/4” Mathematician Mixing Valve, Using both outlets could result in differential sutler temperatures, For o ub & shower application, the bottom outlet can be used for a tub spout and the top outlet for a shower outlet, provided Beth cutlets are not used simultaneously.
4. Remove screws and mounting templates. 6. Remove tha filter screen vivas using the hex wrench (included). ante © 2008 Dane, inc. All rights reserved.
7. install Rushing plugs in filter screen valve seat recesses. 8. Use two hoses fo connect the flushing plugs. Note: hoses not provided. 8 © 2008 Dane, Inc. All rights reserved.
8. Direct the hoses towels the drain and open the stops to flush the piping systems. 18. Close stops completely. Remove hoses and flushing plugs. ante © 2008 Dane, inc. All rights reserved.
. Reinstall the filter screen valves. Make sure the screens are free from sediment or debris. 12. Open tha viols. ig © 2008 Dane, Inc. All rights reserved.
1.3. Reinstall mounting tempts. 14. Turn on the water supply lines fo the valve, and check for leaks, tum off the weer and com plats the finish wall. ante © 2008 Dane, inc. All rights reserved.