Operation Manual

INSTRUCTION MANUAL 34
Basic operation
Switching the Plasma-TV on and off
Press the Power button on the remote control. The PDP will turn on and you will be ready to use all its features.
You can also use the Power button on the front panel of the appliance.
NOTE
*
If your monitor does not switch on operating the switch-on button: Press the MODE button and check if the screen mode was
selected.
Tuning TV channels
1. Connect the signal source to the TV input. Press the TV/VIDEO key on the remote control and select TV on the
screen display (OSD).
2. Use the PG+, PG- button or the numeric buttons to change TV programme for your programme selection.
3. Press PRE PG button on the remote control to tune to the previous programme.
4. You can also receive cable programmes using the decoder box. For further information regarding cable TV
service, contact cable TV service provider(s).
Volume control
Press the VOL+/VOL button.
Press MUTE button on the remote control to cut the sound temporarily.