Owner's Manual

15
CLEANING
DO NOT ALLOW MOISTURE TO GET INTO KNIFE HUB.
DO NOT USE CAUSTIC OR STRONG DETERGENTS ON
THE SLICER BASE OR COMPONENTS.
NOTE :
The slicer will not operate unless the
knife cover is in place and secure.
Fig. 13-1
CAUTION
CAUTION
9. Now replace the knife cover on top of the knife. Align
the bottom notches of the knife cover with the knobs
located at the bottom of the knife ring guard (Fig.13-1).
The top right of the knife cover also has a hole that fits
over a locator pin at the top of the knife ring guard.
10. Lower the knife sharpener cover.
11. With the slicer table completely closed, wipe the slicer table off by starting at the knife and
pulling towards you. Never wipe the slicer table toward the knife.
12. Clean and wipe down the entire slicer. Use a mild sanitizer if required.