Owner's Manual

23
TROUBLESHOOTING GUIDE
SYMPTOM
Slicer will not start
Slicer not plugged in
breaker tripped
Plug-in slicer
Re-set breaker at power box
Remove an obstacle on slicer
and restart slicer
Move lever to manual position
and restart slicer
Call for service center to repair
blade AC motor
Call for service to adjust slicer
table. Have new knife installed.
Make sure knife cover is
properly installed
Lubricate side rods thoroughly
with mineral oil
Clean stones with alcohol and
brush. Dry stones afterwards
Clean top and bottom of knife
Have stones replaced
Have sharpener adjusted
Place auto engage lever in
“MANUAL”. Re-engage auto-
matic when machine is running
Tighten or adjust food chute
Have defective end weight replaced
Call for service to adjust slicer table
Sharpen knife and make sure
knife and stones are clean
Sharpen or have new knife
installed
Install knife cover
Install knife cover
Press stop button to remove
flashing “2”, wait 10 min, and
restart slicer.
Knife cover removed or not
properly installed
Knife cover removed or not
properly installed
Knife slicer table gap too wide
knife too small 11-1/4” or less
Chute DC motor overheated
Chute DC motor over current
Auto engage lever in automatic
Auto engage mechanism
jammed
Blade AC motor overheated
Dull knife
Knife cover
Knife dirty
Worn stones
Stones not properly aligned
Food chute
End weight
Slicer thickness table
Chipped knife
No lubrication
Stone dirty, wet or clogged
with grease
Chute speed light flashing “1”
Chute speed light flashing “2”
Chute speed light flashing “3”
Chute speed light flashing “4”
Chute speed light flashing “5”
Ragged cuts-poor yield
Metal rubbing knife
Hard to push food chute
Hard to sharpen
Automatic food chute won’t
move. NOTE : Knife motor
must be ON in order for
chute motor to start.
The power indicator light
will flash (Manual type).
POSSIBLE CAUSE POSSIBLE SOLUTION