Owner's Manual

15
TROUBLESHOOTING GUIDE
SYMPTOM
Knife is not rotating
Power cord not plugged in
Switch off
V-belt broken
Plug in power cord
Turn switch on
Call for service to replace V-belt
Bad cuts
Dull Knife
Too much grinding on the
front side of knife
Knife is worn
Knife gauge plate gap
too wide
Knife is too small
Sharpen the knife
Hard to push food chute No lubrication Lubricate slide rod
Metal noise Knife cover
Food chute
Gauge plate
Tighten knife cover release knob
Tighten or adjust food chute knob
Call for service to adjust
gauge table
Hard to sharpen Knife dirty
Grinding stones dirty, wet or
clogged with grease
Worn stones
Stones not properly aligned
Clean the both side of knife
Clean stones with brush and dry
Replace the stones
Call for service to adjust
sharpener
Resharpen the knife
Sharpen or replace the knife
Call for service to adjust gauge
table
Replace the knife
POSSIBLE CAUSE POSSIBLE SOLUTION