Datasheet

ManualsBrandsGERMAN REPRAP Manuals3D PrintingFilament PLA plastic 1.75 mm Black 750 g

Februar , 2014

Technical Data Sheet

PLA – Polylactide Cas No. 9051-89-2

PLA is a thermoplastic resin derived from annually renewable resources

Product Characteristics

Typical Properties Value Unit

Physical

Density 1,25 +/-0,05 g/cm³

Melt Index (190°C/2.16kg) 2 - 10 g/10min

Melting Point 170 – 180 °C

Glass Transition Temperature 60 – 63 °C

Mechanical

Tensile Strength >= 50 MPa

Elongation at Break >3 %

Impact

Impact Strength (Izod) 3 – 5 kJ/m²

Further Information

Hazards Identification:

Emergency Overview: This product with no health hazards reported from normal use.

Thermal decomposition can create toxic vapours, gases or fumes.

Route of entry: Inhalation, skin contact, eye contact, ingestion.

Eye: Dust may cause irritation or corneal injury due to mechanical action. Fumes released

during hot operation may cause eye irritation.

Skin: May cause skin irritation for certain people.

Ingestion: May be harmful if swallowed.

Inhalation: Fumes generated under heat may cause irritation to upper respiratory tract and

lungs.

Summary of content (5 pages)

PAGE 1
Februar , 2014 Technical Data Sheet PLA – Polylactide Cas No. 9051-89-2 PLA is a thermoplastic resin derived from annually renewable resources Product Characteristics Typical Properties Physical Value Unit Density Melt Index (190°C/2.
PAGE 2
First Aid Measures: Eye Contact: Wash eyes with plenty of water for at least 15 minutes, lifting lids occasionally to remove particles. Seek medical aid. Skin Contact: Wash exposed area with soap and water. If irritation persists, seek medical attention. Remove contaminated clothing and shoes. Wash clothing before reuse. Thoroughly clean shoes before reuse. Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen.
PAGE 3
Storage: Store in a cool, dry, and well-ventilated area and away from sources of ignition, excessive heat and direct sunlight. Keep container closed when not I use. Protect from physical damage. Separate from combustible and strong oxidizing agents. Put it lightly when packing and transport, prevent the packing and container from damage. Exposure Controls/Personal Protection: Signs and Symptoms of Exposure: There are no significant health hazards under normal conditions of use.
PAGE 4
Physical and Chemical Properties: Appearance and Odor: sweet Solubility in Water: Insoluble. Specific Gravity (H2O=1): 1.25 Melting Point: 170-180° C Molecular Weight: 70000-110000 Stability and Reactivity: Stability: The product is considered stable under normal conditions. Hazardous Polymerization: Will not occur Incompatibility – Materials to Avoid: Incompatible with strong oxidizing agents. Hazardous Combustion Products: Combustion may produce carbon dioxide and carbon monoxide.
PAGE 5
Ecological Information: Environmental Toxicity: On the basis of available information, this product is not expected to produce any significant adverse environmental effects when recommended use instructions are followed. Disposal Considerations Waste Disposal Method: Put into dustbin, otherwise incineration, otherwise licensed landfill, or safe disposal as required by local, state, federal, international or country specific regulations.