Poseidon 2 User Guide 128303775 c (09.
Copyright © 2015 Gerni
Contents 1 Introduction .................................................................................................. 4 1.1 Symbols used to mark instruction .......................................................................4 2 Safety precautions and working techniques ................................................4 3 Description ................................................................................................. 10 3.1 Application ...............................................
1 Introduction 1.1 Symbols used to mark instruction All pictograms attached to the high pressure washer and its components are shown and explained in this manual. Safety instructions marked with this symbol must be observed to prevent personal injury or serious damage to property. Caution where there is a risk of damaging the machine or its individual components. This symbol indicates tips and instructions to simplify work and to ensure a safe operation of the high pressure washer.
the machine to another function. • Observe the national safety regulations issued, for example, by the employers liability insurance association, social security institutions, occupational safety and health authorities or other organizations. Accessories and spare parts • To ensure the machine safety only use original spare parts from Gerni or approved by Gerni. • High pressure hoses, fittings and couplings are important for the safety of the machine.
• Wear shoes with non-slip soles. • Wear goggles, ear protection and protective clothes during operation. Transporting the high pressure washer • When transporting the machine in or on a vehicle, it must be secured, e.g. with straps, so that it cannot slip or tip over. • Gerni recommends that the machine is positioned horizontally on the backside, when transported in or on a vehicle. Detergents • This machine has been designed for use with cleaning agents supplied or recommended by Gerni.
• • • • • • made by a certified electrician and comply with IEC 60364-1. It is recommended that the electrical supply to the machine should include a residual current device that will interrupt the supply if the leakage current to earth exceeds 30 mA for 30 ms. Due to the high power consumption of the machine an appropriate mains fuse is required. Inadequate extension cables can be dangerous.
Safety devices Locking device on spray handle: • The spray handle features a locking device. When the pawl is activated, the spray handle cannot be operated. Thermal sensor: • A thermal sensor protects the motor against overloading. The machine will restart after a few minutes when the thermal sensor has cooled. Pressure safety device: • An integrated hydraulic safety valve protects the system from excessive pressure.
• The machine shall be operated in an upright position. • If the machine is left or not used for 5 minutes, it must be switched off on the start/stop switch "O" (1). After finishing the work WARNING! • Always switch off the machine and unplug the power plug from the socket after work and when leaving the machine unattended. • Disconnect water inlet hose between machine and water supply. • Always empty pump, hose and accessories of water after use of the machine and prior to storing.
3 Description 3.1 Application This high-pressure washer has been developed for semiprofessional routine cleaning: Only use the high-pressure washer for purposes described in this manual. - Professional craftsman jobs, cleaning of vehicles, boat, caravan and minor cleaning jobs within building and construction The safety precautions must be observed to prevent damage to the machine, the surface to be cleaned or severe personal injuries.
4 Before you start using your pressure washer 4.1 Mounting of holders for spray lance Mount the holders for spray lance on the machine. 4.2 Mounting of hose hook (only models without hose reel) Mount the hose hook (12) on the handle (2 screws). Note: the hose hook can be mounted on the front as well as on the back. Front position is to be used if the product is used together with a special wall hook for wall storage. 4.3 Mounting of quick coupling 1.
Attach the high pressure hose (4) to the spray handle (7). 4.4 Mounting of high pressure hose 5 Operating your pressure washer 5.1 Connection of high pressure hose Attach the high pressure hose (4) to the high pressure connection of the machine (3). Only max. 7 m additional extension hose can be added. 5.2 Mounting of spray lance A B NOTE! Always remove any dirt from the nipple before connecting the spray lance to the spray handle. 12 1.
5.3 Water connection An ordinary 1/2" garden hose of min. 10 m and max. 25 m will be suitable. NOTE: Connection to the public mains according to regulations. IMPORTANT! Only use water without any impurities. If there is a risk of silt, sand or sediment in the inlet water (i.e. from your own well), an additional filter should be mounted. 1. Let the water run through the water hose before connecting it to the machine to prevent sand and dirt from penetrating the machine.
5.6 Start the machine (when connected to open containers (suction mode)) 3. Shut off the water supply and activate the trigger to relieve the machine of pressure. 4. Lock the spray handle. When releasing the trigger of the spray handle, the machine automatically stops. The machine will start again when you re-activate the spray handle. The washer can take in water from a rain water tank as an example. The hose for the water supply must not be too long, approx. 5 m. hose in a tank or bucket.
The cover has a standard thread and fits common detergent containers. If your container does not have a standard thread, detach the filter from the suction hose and remove the cover. 5.9 Regulation of pressure / water volume 6 Remount the filter in the suction hose. Extra detergent hose can be pulled out of the machine. Working pressure and water volume can be regulated on the machine by turning the button for regulation of pressure / water volume (6). Fields of application and working methods 6.
7 After using your pressure washer 7.1 Storing the washer 7.2 Winding up of electric cable and high pressure hose The machine should be stored in a frost-free room! Pump, hose and accessories should always be emptied of water prior to storing as follows: 1. Stop the machine (turn the start/stop switch (1) to position “O” and detach water hose and accessory. 2. Restart the machine and activate the trigger. Let the machine run until no more water runs through the spray handle. 3.
8 Maintenance WARNING! Always disconnect the electrical plug from the socket prior to maintenance or cleaning. To ensure a long and problem free working life, please take the following advice: Clean the connectors of dust and sand. Clean the nozzles. Any repair should always be made in an authorized workshop with original spare parts. Wash off water hose, high pressure hose, spray lance and accessories before mounting. 8.
9 Trouble-shooting Please ensure that you check the following before contacting the Gerni service organization: Symptom Cause Recommended action Machine refuses to start Machine not plugged in Defective socket Fuse has blown Defective extension cable Plug in machine. Try another socket. Replace fuse. Switch off other machines. Try without the extension cable. Fluctuating pressure Check that hoses and connections are airtight.
10 Further information 10.2 Warranty conditions Our general conditions of business are applicable with regard to the guarantee. Subject to change as a result of technical advances. 11 Main Technical Data Type POSEIDON 2-22 Electrical Specification Rated voltage V 230-240 Rated frequency Hz 50 Rated power consumption kW 2.3 Current A 11.0 Protection class Class I/ Class II Protection degree IP xx Class I IPX5 Hydraulic specification Rated pressure MPa/bar 12/120 Max.
12 EU Declaration of Conformity We, Nilfisk A/S Kornmarksvej 1 DK-2605 Broendby DENMARK Hereby solely declare, that the product: Product Description Type HPW - Consumer 230-240 V 1~, 50 Hz, IPX5 Poseidon 2-22 Is in compliance with the following standards: Id and Version Title EN 60335-1:2012 Household and similar electrical appliances - Safety - Part 1: General requirements EN 60335-2-79:2012 Household and similar electrical appliances - Safety - Part 2-79: Particular requirements for high pres
12
AUSTRALIA: NEW ZEALAND: Nilfisk Pty Ltd Unit 1/13 Bessemer Street Blacktown NSW 2148 Accent Tools Ltd 232 Bush Rd Albany Auckland 0632 Phone: 1300 556 710 E-mail: info.au@nilfisk.com Phone: 09 968 2610 E-mail: sales@accent-tools.co.