User's Manual
Table Of Contents
- 3-1 Introduction
- 3-2 Running SETUP and Moving Around
- 3-2.1 Main
- Moving Around and Making Selections
- Using the Keyboard
- Main Menu
- Fast Boot
- Boot Sequence
- COM Port
- IR Mode
- LPT Port
- LPT Extended Mode
- Save To Disk Warning Message
- Keyboard Numlock
- Pointing Device (PS/2 Mouse)
- Hot Key Beep
- Cache Systems
- 3-2.3 Security Menu
- System Password
- SCU Password
- F
- Virus Alert
- BootSector Protect
- 3-2.4 Power Menu
- Enable Power Management
- Max Performance/Balanced Power Saving/Max Power Saving/Customize
- Customizing Power Management Features
- Hard Disk Time-Out
- Standby After
- Suspend After
- Suspend Data to
- Battery Low Warning Beep
- VGA Activity
- Resume on Time
- Hour/Minute/Second
- Intel® SpeedStep
- 3-2.5 Exit Menu
Rev. 00 3-17
power up again when next accessed.
The available options are Disabled, 1 Min, 2 Min, 4 Min, 8 Min, 10 Min,
15 Min and 20 Min.
Standby After
The “Standby After” item sets the time-out period for initiating Standby
mode. If the notebook remains idle until the time-out period for Standby
mode has been reached, the notebook enters Standby mode.
In Standby mode, several system components go into standby or off mode
so that system power will be reduced. The system will wake up from
Standby mode when a key is pressed on the internal or external keyboard or
a button is pressed on internal or external PS/2 mouse.
The available options are Disabled, 1 Min, 2 Min, 4 Min, 6 Min, 8 Min, 12
Min and 16 Min.
Suspend After
The “Suspend After”item sets the time-out period for initiating Suspend
mode. It works in conjunction with the previous item “Standby After”.
After the notebook enters Standby mode, the Power Saving starts the
time-out for the Suspend mode. If the notebook remains in Standby mode
until the time-out period for Suspend mode has been reached, the notebook
enters Suspend mode.
The Suspend mode is determined by the next item, “Suspend Data to.” It
can be either Suspend-to-RAM or Suspend-to-Disk.