User's Manual
Table Of Contents
- 3-1 Introduction
- 3-2 Running SETUP and Moving Around
- 3-2.1 Main
- Moving Around and Making Selections
- Using the Keyboard
- Main Menu
- Fast Boot
- Boot Sequence
- COM Port
- IR Mode
- LPT Port
- LPT Extended Mode
- Save To Disk Warning Message
- Keyboard Numlock
- Pointing Device (PS/2 Mouse)
- Hot Key Beep
- Cache Systems
- 3-2.3 Security Menu
- System Password
- SCU Password
- F
- Virus Alert
- BootSector Protect
- 3-2.4 Power Menu
- Enable Power Management
- Max Performance/Balanced Power Saving/Max Power Saving/Customize
- Customizing Power Management Features
- Hard Disk Time-Out
- Standby After
- Suspend After
- Suspend Data to
- Battery Low Warning Beep
- VGA Activity
- Resume on Time
- Hour/Minute/Second
- Intel® SpeedStep
- 3-2.5 Exit Menu
Rev. 00 3-3
! The right column of the screen gives help information of the selected
item.
! The bottom lines of the screen give keyboard instructions for moving
around and making selections.
3-2.2 Moving Around and Making Selections
You must go through two or three levels to complete the setting for an
item. In most cases, there are three levels: menu title, pull-down menu, and
submenu.
To move around and make selections, you can use both the
touchpad/mouse and keyboard.
You’re advised to use the touchpad or mouse. It is more straightforward
than using the keyboard.
For most items, simply move the pointer with the touchpad/mouse and
click on your selection with the left button. To cancel your selection, click
the right button. For a few items, you will need to use the keyboard for
making selections.
Using the Keyboard
Keyboard information can be found at the bottom of the screen. You can
also use shortcut key, which is highlighted by a different color on the
screen.
Described below is the general procedure for using the keyboard to
complete setting of an item: