User's Manual
Table Of Contents
- 3-1 Introduction
- 3-2 Running SETUP and Moving Around
- 3-2.1 Main
- Moving Around and Making Selections
- Using the Keyboard
- Main Menu
- Fast Boot
- Boot Sequence
- COM Port
- IR Mode
- LPT Port
- LPT Extended Mode
- Save To Disk Warning Message
- Keyboard Numlock
- Pointing Device (PS/2 Mouse)
- Hot Key Beep
- Cache Systems
- 3-2.3 Security Menu
- System Password
- SCU Password
- F
- Virus Alert
- BootSector Protect
- 3-2.4 Power Menu
- Enable Power Management
- Max Performance/Balanced Power Saving/Max Power Saving/Customize
- Customizing Power Management Features
- Hard Disk Time-Out
- Standby After
- Suspend After
- Suspend Data to
- Battery Low Warning Beep
- VGA Activity
- Resume on Time
- Hour/Minute/Second
- Intel® SpeedStep
- 3-2.5 Exit Menu
Rev. 00 3-5
IDE Settings
The “IDE Settings” item sets the type of the hard disk drive in your system.
When this item is selected, the submenu will display as shown below.
Select the highest timing which system will set for the IDE drive or select
Standard to disable it.
If the drive cannot support this timing, system will choose available one.
Drive 0 is your primary and Drive 1 your secondary.