User's Manual
Table Of Contents
- M230-0.doc
- M230-1.doc
- M230-2.doc
- M230-3.doc
- M230-4.doc
- M230-5.doc
- M230-6-0907.doc
- M230-7.doc
- M230-8.doc
- Troubleshooting
- Preliminary Checklist
- Solving Common Problems
- Battery Problems
- Bluetooth Problems
- Optical Drive Problems
- Display Problems
- Hardware Device Problems
- Hard Disk Drive Problems
- Infrared Problems
- Keyboard, Mouse and Touchpad Problems
- LAN Problems
- WLAN Problems
- Modem Problems
- PC Card Problems
- Power Management Problems
- Printer Problems
- Software Problems
- Sound Problems
- Startup Problems
- Other Problems
- Resetting the Computer
- Troubleshooting
- M230-A.doc
- M230-B updated.doc
5. Slide the new battery pack all the way into the slot. Make sure to
observe the correct orientation (the ribbon strip must face outward for
future battery back removal).
6. Close the slot cover to secure the battery pack.
Installing the Secondary Battery Pack
If you often rely on battery power for a long period of time while
traveling, you may consider the purchase of an additional battery pack
from your dealer and keep it with you in a fully charged state as a backup.
To install the secondary battery pack, follow these steps:
1. Make sure the computer is not turned on or connected to AC power.
2. Locate the optical drive slot on the left side of the system.
3. Gently place the computer upside down.
4. Open the slot cover by pressing on both sides of the release latch
using your thumb and index fingers.
5. Lift up the handle of the optical drive release knob and turn it
counter-clockwise.
3-6 Managing Power