User Manual

The computer does not enter Standby or Hibernation mode
immediately.
 If the computer is performing an operation, it normally waits for the
operation to finish.
The computer does not resume from S
tandby or Hibernation mode.
 The computer automatically enters Standby or Hibernation mode
when the battery pack is empty. Do any one of the following:
− Connect the AC adapter to the computer.
− Replace the empty battery pack with a fully charged one.
The computer does not enter Hibernation mode with the
Fn+F10 hot
keys.
 Make sure that the Hibernation function is specified for the sleep
button.
Printer Problems
The printer does not work.
 Make sure that the printer is turned on (if it comes with an
independent power source) and is online (ready to use).
 Make sure that the printer’s signal cable is properly connected.
 Make sure that the printer driver is correctly installed.
 Make sure that you have assigned the printer port correctly in your
operating system or application program.
 Make sure that the printer port is enabled in the SCU program.
The printer prints garbled information.
 Make sure that the printer driver is correctly installed.
 Make sure that the printer cable is properly connected.
8-12 Troubleshooting