User Manual
Table Of Contents
- M230-0.doc
- M230-1.doc
- M230-2.doc
- M230-3.doc
- M230-4.doc
- M230-5.doc
- M230-6-0907.doc
- M230-7.doc
- M230-8.doc
- Troubleshooting
- Preliminary Checklist
- Solving Common Problems
- Battery Problems
- Bluetooth Problems
- Optical Drive Problems
- Display Problems
- Hardware Device Problems
- Hard Disk Drive Problems
- Infrared Problems
- Keyboard, Mouse and Touchpad Problems
- LAN Problems
- WLAN Problems
- Modem Problems
- PC Card Problems
- Power Management Problems
- Printer Problems
- Software Problems
- Sound Problems
- Startup Problems
- Other Problems
- Resetting the Computer
- Troubleshooting
- M230-A.doc
- M230-B updated.doc
6. The optical drive will slide out partially. Gently pull on it to remove
it.
7. Slide the secondary battery pack all the way into the slot. Make sure
to observe the correct orientation (the ri
bbon strip must face outward
for future battery pack removal).
8. Close the slot cover to secure the secondary battery
NOTE: The system supports the secondary battery hot-swap function, providing you
the ability to replace the battery even during system on. Hot swap means that you can
remove the secondary battery pack and replace it with another one without significant
interruption to the system (without turning off the system).
Battery Low Signals and Actions
Battery Low occurs when the battery has approximately 10 % (Windows
default setting) of its charge remaining. The computer gives warning
messages and the Battery Power Indicator (
) blinks amber (orange) to
alert you to take actions.
NOTE: You can set up your threshold and signals of Battery Low under Windows.
Immediately save your data upon Battery Low. The remaining operating
time depends on how you are using the computer. If you are using the
audio subsystem, hard or optical drives, PC card, the battery might run
out of charge very quickly.
Managing Power 3-7