CastleNet BTC04R User Guide User Guide Bluetooth2.1+EDR Module CastleNet Technology Inc. Copyright © 2008 All Rights Reserved.
CastleNet BTC04R User Guide Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
CastleNet BTC04R User Guide This device is intended only for OEM integrators under the following conditions: TANT NOTE: In the event that these conditions can not be met (for example certain laptop LABEL OF THE END PRODUCT: configurations co-location another in transmitter), then with the FCC authorization is no longer The final end or product mustwith be labeled a visible area the following" Contains TX FCC ID: MAU041 TheFCC FCCIDpart has toInalso be circumstances, available on the considered valid and".
CastleNet BTC04R User Guide Canada-Industry Canada (IC) Operation is subject to the following two conditions: this device may not cause interference and this device must accept any interference, including interference that may cause undesired operation of the device. IMPORTANT NOTE: IC Radiation Exposure Statement: This equipment with IC radiation exposure limits set forth for an uncontrolled environment.
CastleNet BTC04R User Guide 1. INTRODUCTION The BTC04R series is a embedded Bluetooth module, smallest form factor for Notebook and handheld PC. The Bluetooth function is based on CSR BlueCore4-ROM A07 single chip, which is fully compliant with Bluetooth 2.1 specification plus EDR. It has good RF performance. Lowest power consumption, piconet and scatternet capability. The interface is HCI USB compliant with USB fully speed (12Mbits).
CastleNet BTC04R User Guide 2. INSTALLATION 2.1 Installed in Laptop PC The Mainboard of the system should provide a Host connector and Cable connection for BT module. Please follow the SOP to install & assemble it step by step. 2.2 Testing in Lab The module is embedded inside Notebook. If for testing purpose, we provide the “USB Testing Board” in order to let tester connect BTC04R via the special cable connection to PC externally. The USB Testing Board provides +5V/3.3V conversion from PC Host.
