Rugged Wireless Keyboard User Guide April 23, 2003 P/N:799001200026 R00
Table of contents 1.0 Introduction ....................................................... 1 1.1 RED LED .......................................................... 2 1.2 DIP Switch......................................................... 2 2.0 Technical Specification ..................................... 3 2.1 Using the Rugged Wireless Keyboard............... 3 2.2 Function Key and Indicator ............................... 4 Figure of Contents Figure 1 Turn on the Switch .......................
Regulations Information Class B Regulations USA Federal Communications Commission Radio Frequency Interference Statement NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Please note: The use of a non-shielded interface cable with this equipment is prohibited. Canada Canadian Department of Communications Radio Interference Regulations Class B Compliance Notice This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.
1.0 Introduction This user guide provides information about the use of the Rugged Wireless keyboard. Note Before using the optional keyboard for the first time, slide the switch located inside the power jack port to the “on” position. The power jack port is found on the right side of the wireless keyboard. (See figure 1) Push Display battery power percentage ON Figure 1 Turn on the Switch Rev.
1.1 RED LED Red LED display the percent of the battery power, when pressing the push button, each LED shows the 25% power. If power range fall in 75%-100%, then four LEDS will be on. Push Switch RED LED 1.2 Dip Switch The power jack port has four switches. The sequence from left to right is battery switch, wake up switch, sleep switch and power switch. They match to buttons on the keyboard, so we can enable/disable the button by setting switch off/on. Rev.
2.0 Technical Specification Dimension Weight 325.7 X 174.8 X 27.5mm 1.3Kg Number of Keys 87 Key Battery life 15 hours ( keep backlight on ) AC Adaptor Input:110-240V, 50/60Hz, 1.0A max. Output: 12V, 1.5A max. IO port IR port 2.1 Using the Rugged Wireless Keyboard Place the wireless keyboard in front of the Tablet PC with no obstructions between them to allow unhampered communication between the computer and keyboard’s IR port. Rev.
2.2 Function Keys & Indicator 1. Left Button: Left button of the mouse. 2. Right Button: Right button of the mouse. 3. Backlight Key: When the user presses the backlight key, the backlight will be set on or off . Once the keyboard backlight turn on and the user doesn’t operate keyboard for about thirty seconds, the backlight will automatic turn off, user can press any key or backlight key to turn on again. 4. Power: When press the power button under Windows use, the system will power off.
7. CHARGE LED: Green: In Charge Turn off: Full Charge (If connected to the AC-IN.) 8. Battery LED: This led is Yellow . When battery power is less then 5% power, the led is blink. When the led is on, ( not blink anymore), the backlight will be off automatically, that mean the battery power is about 0%, and user need to connect to adapter immediately. 9. FSR: Serves as the pointing device of the rugged wireless keyboard.