User's Manual
Table Of Contents
- Chapter 1 Getting Started
- Chapter 2 Operating Your Tablet PC
- Chapter 3 Managing Power
- Chapter 4 Expanding Your Tablet PC
- Chapter 5 Using BIOS Setup
- Chapter 6 Using Getac Software
- Chapter 7 Care and Maintenance
- Chapter 8 Troubleshooting
- Preliminary Checklist
- Solving Common Problems
- Resetting the Tablet PC
- System Recovery
- Using the Driver Disc (Optional)
- Appendix A Specifications
- Appendix B Regulatory Information
19
Using Network and Wireless
Connections
Using the LAN
Your Tablet PC has two LAN modules so you can connect to two networks at
the same time.
To connect the network cable to the LAN module, connect one end of the
LAN cable to the RJ-45 connector on the Tablet PC and the other end to the
network hub.
NOTE: LAN2 module implements DSM (Deep Slumber Mode) to save battery
power. Power is supplied to the LAN module only when the LAN cable is
connected. This means the LAN module will not appear in Windows’ Device
Manager if the LAN cable is not connected and will appear if the cable is
connected.
LAN2
LAN1