User's Manual
Table Of Contents
- Chapter 1 Getting Started
- Chapter 2 Operating Your Tablet PC
- Chapter 3 Managing Power
- Chapter 4 Expanding Your Tablet PC
- Chapter 5 Using BIOS Setup
- Chapter 6 Using Getac Software
- Chapter 7 Care and Maintenance
- Chapter 8 Troubleshooting
- Preliminary Checklist
- Solving Common Problems
- Resetting the Tablet PC
- System Recovery
- Using the Driver Disc (Optional)
- Appendix A Specifications
- Appendix B Regulatory Information
36
Replacing the Battery Pack
CAUTION:
There is danger of explosion if the battery is incorrectly replaced. Replace the
battery only with the Tablet PC manufacturer’s battery packs. Discard used
batteries according to the dealer’s instructions.
Do not attempt to disassemble the battery pack.
NOTE: You can hot swap one battery pack while the other one is supplying the power.
To replace the battery pack, follow these steps:
1. Locate the battery pack you want to remove ( or ).
2. Slide the battery latch toward the right (
) and then upwards (
) to release the
battery pack.
3. Remove the battery pack from its compartment.
4. Fit another battery pack into place. With the battery pack correctly oriented,
attach its connector side to the battery compartment at an angle (
) and then
press down the other side (
).