User's Manual

53
 Graphics Setup
DVMT Pre-Allocated sets the amount of pre-allocated (fixed) graphics memory for
use by the internal graphics device.
 Device Configuration enables or disables several hardware components. The items
available for setting depend on your model.
 Recovery Partition allows you to restore your Windows 10 system to the factory
default state by using the “recovery partition” feature. Recovery partition is a
portion of your hard disk drive that is set aside by the manufacturer to hold the
original image of your system.
WARNING:
 Using this feature will reinstall Windows to your system and configure it to the
system’s factory default settings. All data on the hard disk drive will be lost.
 Make sure that power is not interrupted during the recovery process. An
unsuccessful recovery may result in Windows startup problems.
 Windows RE launches Windows Recovery Environment. Windows RE (Windows
Recovery Environment) is a recovery environment that provides recovery, repair,
and troubleshooting tools in Windows 10.
Security Menu
The Security menu contains the security settings, which safeguard your system against
unauthorized use.
NOTE:
 You can set the user password only when the supervisor password has been set.
 If both the supervisor and user passwords are set, you can enter any of them for
starting up the system and/or entering BIOS Setup. However, the user password
only allows you to view the settings of certain items.
 A password setting is applied right after it is confirmed. To cancel a password, leave
the password empty by pressing the Enter key.
 Set Supervisor/User Password sets the supervisor/user password. You can set the
supervisor/user password to be required for starting up the system and/or
entering BIOS Setup.
 Password on Boot allows you to enable or disable the entering of password for
booting up your system.