User's Manual
Table Of Contents
- Chapter 1 Getting Started
- Chapter 2 Operating Your Tablet PC
- Chapter 3 Managing Power
- Chapter 4 Expanding Your Tablet PC
- Chapter 5 Using BIOS Setup
- Chapter 6 Using Getac Software
- Chapter 7 Care and Maintenance
- Chapter 8 Troubleshooting
- Preliminary Checklist
- Solving Common Problems
- Resetting the Tablet PC
- System Recovery
- Using the Driver Disc (Optional)
- Appendix A Specifications
- Appendix B Regulatory Information
74
Make sure that the sound is not muted.
Make sure that the Tablet PC is not in Sleep mode.
If using an external speaker, make sure that the speaker is properly connected.
Distorted sound is produced.
Make sure that the volume control is not set too high or too low. In most cases, a
high setting can cause the audio electronics to distort the sound.
Startup Problems
When you turn on the Tablet PC, it does not respond and the Power Indicator
does not light green.
If you are using an external AC power, make sure that the AC adapter is correctly
and securely connected. If so, make sure that the electrical outlet works properly.
If you are using the battery power, make sure that the battery is not discharged.
When the ambient temperature is below -20 °C (-4 °F), the Tablet PC will start up
only if both battery packs are installed.
When you turn on the Tablet PC, it stops after POST.
Reset your Tablet PC.
WLAN Problems
I cannot use the WLAN feature.
Make sure that the WLAN feature is turned on.
Transmission quality is poor.
Your Tablet PC may be in an out-of-range situation. Move your Tablet PC closer to
the Access Point or another WLAN device it is associated with.
Check if there is high interference around the environment and solve the problem
as described next.