Owner's Manual
5-12
Using BIOS Setup and System Recovery
typing it again and pressing Enter. You can set the supervisor/user password
to be required for starting up the system and/or entering BIOS Setup.
Password on Boot allows you to enable or disable the entering of password
for booting up your system. Once the password is successfully set and this
item is enabled, it is required for booting up the system.
Set HDD 0 Password sets the password for locking the Primary Master hard
disk drive. After setting a password, the hard disk drive can only be
unlocked by the password no matter where it is installed.
HDD 0 Password Is shows whether you have set the hard disk password or
not.
TPM Setup sets various TPM parameters. Press Enter to access the submenu
as shown below.
TPM Support enables or disables TPM support (see chapter 6 for details).
Current TPM State shows the current TPM state.
Change TPM State allows you to select between
No Change
,
Clear
,
Deactivate & Disable
, and
Enable & Activate
.
Information Main Advanced Security Boot Exit
TPM Setup Menu Item Specific Help
TPM Support
Current TPM State:
Change TPM State
[Enter ]
Disabled & Deactivated
[No Change ]
Enable Trusted Platfor
m
Module support
F1 Help ↑↓ Select Item -/+ Change Values F9 Setup Defaults
Esc Exit ←→ Select Menu Enter Select X Sub-Menu F10 Save and Exit
Enabled